Easter 3D Bunny Countdown Tag or Magnet with Carrot lever to spin around and Easter Egg

Description:
This purchase includes a file for making this cute bunny layered Countdown to tag or magnet with a engraved front design and a layered bunny.
A spinning wheel and a layered carrot on the lever to make it slide.
The Countdown is counting down from 14 days and will show a scored egg in the end.

No hardware is needed to make these and assembling take less than 10 minutes.
Here's a quick YouTube tutorial on how I made this one - more can be found on my channel:
https://youtu.be/VBAgiTUOaFk?si=MYiwV0Jk6bNpewFt
You can also find all my tutorials in my helping group, by following the link below.

You can personalize the front as you wish and mix and match the included elements.

The file is made for engraving and scoring and the pictured pieces is cut from 4mm (1/8”) plywood.
The finished countdown set to measure approximately 4” / 10cm.
You can use any thickness of material, but I recommend thinner material.

Make sure to sand the slider part on both sides, so you remove a little material and make it nice and smooth, which will make the sliding go easier. Optional you can add a piece of paper/cardboard on the center round, to make it a tiny bit thicker or use a stapler like me.
Apply glue to the middle center piece of the slider and glue it to the back and front of the ornament.
Optionally (and recommended) use a stapler and staple it to the back, this will help lifting the front a bit.
Glue the front in place and add the layered bunny.
You can use whatever thickness of material as well as resize it as long as you resize everything.

For more questions or info on my files and products, feel free to join my helping group Laser up with MiMo Design on Facebook.
https://www.facebook.com/groups/3009939039221973/
Or our All Stars Community Group:
https://www.facebook.com/groups/284423150964862/?ref=share_group_link